Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


DISCLOSURE: We may earn a commission when you use one of our coupons/links to make a purchase.
  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Capacitor on reversing dryer and roller machine


Keinokuorma

Recommended Posts

Referring to this old, closed thread:

http://www.applianceguru.com/forum2/3943.html

On the reversing dryers that I have seen, as well as many laundry roller machines it is common that the motor is equipped with a capacitor, and no specific start winding.

the motor itself is a 3 phase designed induction motor (not single phase shaded pole), where the capacitor is connected between two windings, Neutral is fed to the third, and direction is determined by which leg of the capacitor Live is fed.

capmotor.bmp

Link to comment
Share on other sites

  • Replies 2
  • Created
  • Last Reply

As this old thread has started up again http://www.applianceguru.com/forum2/3943.html

I'd like to put my two cents (Canadian) in = This Frigidaire Gallery dryer was available on the Canadian market for a couple of years, and was indeed a reversing drying (hence the double idler pulley). It was constructed exactly like the old style Westinghouse dryers. They were trying to replicate some of the reversing European dryers (less tangled clothes and more efficient drying when it reverses) The motor was your standard Frig/Westinghouse with the exception it had no motor start switch. The start/stop/reversing was accomplished by a board in the console. It had several relays - one SPST relay to start & stop the motor - one SPST relay to remove the start winding from the circuit and two SPDT relays to facilitate the reversing functions, acting exactly like typical reversing switches The motor started, ran for ? min. paused about 3 sec. , started again for approx. ?min. and repeated. Standard timer, selector switch, push to start (for initial start) etc. If I was at work I could post a schematic - suspect if you went into the Frigidaire site you may find that for those interested. There is a diagram of the board and a logic chart for various cycles.This was just a standard dryer with electronic motor operation - no electronics for dry. Hope this helps - oh and there was no capacitor on the motor.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.


×
×
  • Create New...