Jump to content
Click here to check out our on-demand appliance repair training webinars.

FAQs | Repair Videos | Academy | Newsletter | Contact


DISCLOSURE: We may earn a commission when you use one of our coupons/links to make a purchase.

  • Upcoming Events

    • Appliantology Live Dojo, Saturday, 4/27/2024 @10 AM ET
      27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Sharp CV-P12LX repair/service manual to remove rear cover

dave42

By dave42
in DIY Appliance Repair Help

Recommended Posts

dave42

dave42

Posted
Posted

Hi,

Does anyone have a service/repair manual for Sharp CV-P12LX portable a/c? I just need to remove rear cover as something is rattling constantly with a/c on. I removed all screws, but can't get rear cover off. Thanks.

Dave

Link to comment
Share on other sites
  • Replies 5
  • Created
  • Last Reply
kdog Sensei

kdog

Posted
Posted

Those rear blower wheels are notorious for coming loose, to remove the rear panel, you need to also remove the side panels and there is one screw at the top which goes into the rear panel from the front (6-19 on illustration), they're a bitch to disassemble, make sure you treat the blower wheel setscew to a liberal dose of locktite and retighten

Link to comment
Share on other sites
dave42

dave42

Posted
  • Author
Posted

Thanks kdog,

got the covers off, but not sure how the blower assembly comes out. I removed all the screws, but it does not seem like it wants to come out.

Link to comment
Share on other sites
kdog Sensei

kdog

Posted
Posted

Don't take the blower out- try sliding the wheel back and forth to see if the set srew(bolt) has come loose, it should tighten down to a flat spot on the shaft, if I recall, it is a 10mm bolt, if you have a ratcheting boxwrench, you can squeeze it in there

Link to comment
Share on other sites
dave42

dave42

Posted
  • Author
Posted

I tried it. It wasn't loose. Put the whole mess back together, and so far no rattling. However, I have 3 extra screws! Thanks for your help.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

Go to topic listing
×
×
  • Create New...