Guest Posted August 21, 2009 Share Posted August 21, 2009 Any help or pointers with regard to a service manual or error code list would be helpful. Unit is not spinning out and leaving clothes wet. Not a balance problem. Originally seemed to occur on cold wash cycle, but has happened on warm as well. I know how to enter manual/test mode and run the spin cycle manually, and when doing so I see an E:20, but I have no reference for what that means. Unit is still under warranty so I will have someone come out, but would sure like to have the info for future use. Thanks in advance. Link to comment Share on other sites More sharing options...
RegUS_PatOff Posted August 21, 2009 Share Posted August 21, 2009 I don't have a manual for that model, but for the WFMC3200 / WFMC6400:E:20 Spinning aborted due to unbalanced loadUnbalanced load or faulty wire harness Link to comment Share on other sites More sharing options...
Guest Posted August 21, 2009 Share Posted August 21, 2009 Thanks for the reply - much appreciated. I'll watch for the out of balance condition. I'm not sure that is the problem (or that it isn't It wouldn't surprise me if the error codes are mostly common between these similar units. As I've not heard or felt any signs of serious imbalance from the other room I'm not sure how to prove this one way or the other - short of baby sitting every load until it happens again. From what I can recall, the times where it has not spun out have been with smaller loads, so unbalance may fit. I'll report back if I can provide a definitive answer. Thanks again. Link to comment Share on other sites More sharing options...
trying_to_fix_it Posted April 19, 2010 Share Posted April 19, 2010 Do you have a manual for WFNC5301UC Nexxt 500. My washer is not spinning fast enough after tub, pump, shocks, and board change. I was told that you can force max spin via the service diag mode? Link to comment Share on other sites More sharing options...
RegUS_PatOff Posted April 19, 2010 Share Posted April 19, 2010 may be similarWFMC3200 / WFMC6400 link PM'd Link to comment Share on other sites More sharing options...
Recommended Posts