Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 30 March 2024 02:00 PM Until 03:00 PM
      0  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological: bidness, customers, tools, troubleshooting, flavorite brewski, whatever. Webcams and microphones are open and live!
      This workshop is also a great time for any students at Master Samurai Tech to bring any and all questions about the coursework. We're happy to walk through any concepts you're having trouble with. Think of it like office hours with your teachers. 
      If you have a specific appliance problem you'd like us to talk about, post it here! We need a problem statement and a PDF of the tech sheet or schematic so we can all see it on screen share. If you have a PDF that isn't already in the File library here at Appliantology, send it to us by attaching it to the contact form. 
      Also, follow this Calendar Event so you'll get notified of new posts here. Look for the "Follow" button either at the top of the topic on desktop or below the topic on mobile.
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, March 30 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

DCS 304


nonstop

Recommended Posts

Hello, I am looking for instruction for a nat gas to LP conversion kit for a DCS 304 oven. I believe the orifice should be a 55mm for the LP. For the broiler section.

Link to comment
Share on other sites

  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

  • nonstop

    2

  • appl.tech.29501

    1

Popular Days

Top Posters In This Topic

Do you have the conversion kit? Usually they come with the range...taped on the back.

Link to comment
Share on other sites

Found it, and found the 55 stamped on the orifice after cleaning. Good with that. New issue. The broiler fired up and then makes small popping sounds before one big pop and then jet blows down the vent tube in IR box. Burns a lot louder than I remember. Gas is all burning however it think air low mix off? I checked and the shutter that should be in place for LP conversion is in place as well?

OK looked some other forms on this issue. I would say symptoms similar to

[user=53635]vee8power[/user]

Discribed a few weeks ago with IR burner.

Thought, could i have "cleaned" orifice to well making opening to large? I looked at the screen and it didn't seem that bad. Also could this still be igniter issue?

Could igniter be to close (1/4 inch) from IR screen be issue? Gas ignites in tube and not on screen surface?

Link to comment
Share on other sites


×
×
  • Create New...