Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • Appliantology Live Dojo, Saturday, 4/27/2024 @10 AM ET
      27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

DCS 304

nonstop

By nonstop
in Appliance Service Manual Requests Forum

 Share

Recommended Posts

nonstop

nonstop

Posted
Posted

Hello, I am looking for instruction for a nat gas to LP conversion kit for a DCS 304 oven. I believe the orifice should be a 55mm for the LP. For the broiler section.

Link to comment
Share on other sites
  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

  • nonstop

    2

  • appl.tech.29501

    1

Popular Days

Top Posters In This Topic

Popular Days

appl.tech.29501 Sensei

appl.tech.29501

Posted
Posted

Do you have the conversion kit? Usually they come with the range...taped on the back.

Link to comment
Share on other sites
nonstop

nonstop

Posted
  • Author
Posted

Found it, and found the 55 stamped on the orifice after cleaning. Good with that. New issue. The broiler fired up and then makes small popping sounds before one big pop and then jet blows down the vent tube in IR box. Burns a lot louder than I remember. Gas is all burning however it think air low mix off? I checked and the shutter that should be in place for LP conversion is in place as well?

OK looked some other forms on this issue. I would say symptoms similar to

[user=53635]vee8power[/user]

Discribed a few weeks ago with IR burner.

Thought, could i have "cleaned" orifice to well making opening to large? I looked at the screen and it didn't seem that bad. Also could this still be igniter issue?

Could igniter be to close (1/4 inch) from IR screen be issue? Gas ignites in tube and not on screen surface?

Link to comment
Share on other sites
 Share
Go to topic listing
×
×
  • Create New...