Jump to content
Click here to check out this guide.

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Maytag LSE7806ACE Washer/Dryer Stack


widowbryant

Recommended Posts

  • Replies 6
  • Created
  • Last Reply

Top Posters In This Topic

  • widowbryant

    4

  • RegUS_PatOff

    2

  • Samurai Appliance Repair Man

    1

Top Posters In This Topic

  • Team Samurai

All I have on this one is the parts and wiring diagram. Maybe Master Reg has sumpin up his sleeve.

Link to comment
Share on other sites

widowbryant

Thanks for the try though. *smiling* I have the parts list. Am looking for the service manual.

Thanks again for caring enough to reply.....

rebecca

Link to comment
Share on other sites

widowbryant

The washer drum suddenly stopped spinning, but it pumps out. I smell a bit of burned rubber like when my vacuum belt breaks. The unit is older. I haven't pulled it out of its cubbyhole yet, but ordered both drive belts cause I figure it's probably time to replace them. Already did the dryer belt last year. When the washer belts arrive I'll pull the thing out and replace those, but it might be something else. I read about the transmission, or perhaps an old sock stuck between the the tubs, but can't find a diagram on how to remove the top tub ring. I felt around in there but no socks jumped out. I joined this forum because I thought it'd be good to have a service manual for this thing since it's starting to require the occasional repair. I figure it's a foreboding of things to come, so better get a manual.

I'm a girly farmer living in a rural area and pretty good with fixing things. (Good cause there's no washer repair men roundabouts. *grin* Gal gotta do for herself.)

thank you!

rebecca

Link to comment
Share on other sites

same Washer Tub / Basket / Transmission as Maytag LAT1000 / LAT2000

16010373 Washer service manual

link PM'd

Link to comment
Share on other sites

widowbryant

Thank you for the manual. I'm still trying to narrow down the issue, and have posted in the general washer repair forum.

I appreciate you!

rebecca

Link to comment
Share on other sites


×
×
  • Create New...