Learn how to be your own tech line...

Click here to check out our structured, online appliance repair training courses for rookies and experienced techs.

FAQs | Repair Videos | Academy | Newsletter | Podcast | Contact

Stay connected with us...

Samurai on Facebook - become a fan today! Sign up for our free newsletter and keep up with all things Appliantology. Subscribe to our YouTube channel for lots of appliance repair tips and help! Follow the Samurai on Twitter and get timely morsels of Appliantological Wisdom! Subscribe to our MST Radio podcast to learn secrets of the trade.
  • Announcements

    • Samurai Appliance Repair Man

      Webinar Recordings Index Page   07/27/2017

      One of the benefits of your Professional Appliantologist membership is that you can attend the regular, live training webinars and you have access to the recordings as well. So if you can't make it to the live webinar, catch the recording at your convenience. The webinar recordings are conveniently listed for you on the Webinar Recordings Index Page.   
Sign in to follow this  
dtarlo

Richmond Water Heater Not Heating Properly

Recommended Posts

dtarlo   
dtarlo

I have a 30 Gallon Richmond Water Heater, Model Number 8MV30-2, Upper and lower wattage listed at 4500/3380 each.

It was typically enough water to provide two showers before it ran out. About 3 months ago (yes I have been lazy in dealing with the issue) it started only giving enough water for about one shower.

I eyeballed the top and bottom element from the outside and neither has the appearance of being burned out. To "rectify" the situation, I cranked up the heat, it works, kinda.

I live in an apartment building where the maintenance guy has equal or less skill with this than I do, and the landlady is quite cheap, so replacing it would be like pulling teeth with no anathestic.

Can anyone give me pointers on how to test each of the elements?

I plan to turn off the power next week and drain it, I figure it would be a good time to pull each of the elements to inspect and test them.

Thanks in advance for any help!

D

  • Like 1

Share this post


Link to post
Share on other sites

Need appliance parts? Call 877-803-7957 now!

RegUS_PatOff   
RegUS_PatOff

no need to pull the Elements to test them.

just disconnect them and use an OHM meter

  • Like 1

Share this post


Link to post
Share on other sites
skintdigit   
skintdigit

Sounds like a toasted element. Like RegUS says, just shut off the power, disconnect one wire from each element and check resistance across the two terminals of each element. You can check for resistance from terminals to the tank(ground) if you wish, but a fried element will show up as "open" (infinite resistance).

 

You're paying rent, though. Call the apt. manager and ask them to get your water heater working...it's nearly December, man!

 

SD

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this