Jump to content
Click here to check out our structured, online appliance repair training courses for rookies and experienced techs.

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Kenmore 110.28902790 wiring diagram or ?


pathfinder1941

Recommended Posts

Thought I had isolated no agitator start to open timer node/nodes but new timer was no help.  Need schematic or advice if you have seen this phenom.  Machine fills but motor never activates for agitation.  Timer eventually advances to drain (pump out) but never agitation.

Link to comment
Share on other sites

  • 2 weeks later...

GMF - Thanks for the prompt reply, would that I had checked back right away.  The motor is not activated in agitate, runs fine in spin.   I am going to look at unit again this AM.  Speed switch seems to be critical to the 120vac to motor.   I'll see if I can decifer the schematic on back dash enough to jumper same.

Link to comment
Share on other sites

×
×
  • Create New...