Jump to content
Click here to check out our on-demand appliance repair training webinars.

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

GE Range Model PGB975SEM2SS


Cityboysrus

Recommended Posts

The download section doesn't have this specific model number's Service Manual.

 

I'm receiving a Temp Sensor error with constant beeping.

 

The Temp Probe was replaced with no avail, same symptom.

 

I want to be sure before replacing the Control Board.

Link to comment
Share on other sites

Most GE electric ovens have a 6 or so pin connector on the oven control board. Unplug it and measure the resistance between the two white wires at one end of the connector. About 1100 Ohms at room temperature is correct. Also check that both pins are infinite to ground.

Link to comment
Share on other sites

I'll see if I can find the schematic and upload it for the next person that runs into this model number.

Link to comment
Share on other sites

×
×
  • Create New...