Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Samsung refer RSG257aa**


certified tech group 51

Recommended Posts

Need the service manual to access the Ice dispenser door...........door is loose and flaps in the wind.....Do not need the fast track/diagnostics......Just how to get the dispenser display panel off............Found two release tabs hidden under the panel but control panel will not remove with out a very large  2x4 and a crow bar  :woot:  ......Someone else way back in Oct of 2013? asked for the same service manual for the same repair, not one single response/post....

Link to comment
Share on other sites

  • Replies 4
  • Created
  • Last Reply

Top Posters In This Topic

  • certified tech group 51

    2

  • DurhamAppliance

    2

  • Econo Appliance

    1

Top Posters In This Topic

and...

gallery_51884_80_356317.png

I think I may have done this only once so I can't offer much practical help.

Edited by DurhamAppliance
Link to comment
Share on other sites

Yup, i removed the screw, released the tabs, but the top of the stainless steel panel would not release....pulled a bit but it would not let go........guess I gotta pull harder....Thanks Durham for the info......I ordered the ice route assy, now I gotta get it apart to 'Fix-it'......

Link to comment
Share on other sites

  • 6 years later...
On 10/19/2015 at 8:38 PM, certified tech group 51 said:

Yup, i removed the screw, released the tabs, but the top of the stainless steel panel would not release....pulled a bit but it would not let go........guess I gotta pull harder....Thanks Durham for the info......I ordered the ice route assy, now I gotta get it apart to 'Fix-it'......

Doing the same model at the moment.  WOW the top clips are in there tight!!! Thought i was gonna snap the panel in half, and it popped out.

Link to comment
Share on other sites


×
×
  • Create New...