Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


DISCLOSURE: We may earn a commission when you use one of our coupons/links to make a purchase.

  • Upcoming Events

    • Appliantology Live Dojo, Saturday, 4/27/2024 @10 AM ET
      27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Kitchenaid Built In Won't allow diagnostics or RUN

fixers212

By fixers212
in DIY Appliance Repair Help

 Share

Recommended Posts

fixers212

fixers212

Posted
Posted

I'm near finished this Kitchen aid Built In Refrigerator. Having the Main Control Board Rebuilt and solving 80% and after checking every connection, has left me with No Operation and a In-operable Diagnostic. The Diagnostic access is very intermittent and most of the time displays a 22 on the RC side. It will allow me to change sequence but holds this 22 in the screen. Strangely  enough I can at times access the diagnostics and operate every individual component Including the Inverter compressor but after I Leave the test, and Go to run, No Operation. 

The 22 will come back of course. I am suspecting that this static interface is bad, but Have to be sure.  Can you possibly find out what this 22 means, because it is not mentioned anywhere in the units paperwork. I am missing a command here, but with the cost of this Control Box,  (Interface)  I would like to be sure  

 

Link to comment
Share on other sites
  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

  • AccApp

    1

  • fixers212

    1

  • MoTeD

    1

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

AccApp
AccApp

Contact the rebuilders of the board, they can often help you.

MoTeD

MoTeD

Posted
Posted

This model has service pointers from WP on both the user interface and control boards. There is a new wiring harness included with the new control board kit. 

 

Service pointer for the control boards is W10802724C

Service pointer for the user interface is 4317485

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing
×
×
  • Create New...