Clicky

Jump to content
Click here to check out our structured, online appliance repair training courses for rookies and experienced techs.

FAQs | Repair Videos | Academy | Newsletter | Podcast | Contact

Stay connected with us...

Subscribe to our YouTube channel for lots of appliance repair tips and help! Subscribe to our MST Radio podcast to learn secrets of the trade. Sign up for our free newsletter and keep up with all things Appliantology.

Sign in to follow this  
kokomo

Whirlpool Duet washer WFW9300VU02 "2008"

Recommended Posts

kokomo

Only key that responds on UI is the (press 3 sec to lock out console) with an led comes on. Outlet chks OK, power filter in washer pass's 120 vac out.                                                                                     Couldn't get volts at door switch from two blue wires coming from filter. Unless they detoured in the board didn't want to go there. What to do. Thks.

Share this post


Link to post
Share on other sites

Need appliance parts? Call 877-803-7957 now!

kokomo

User interface ( U I ) no lights at all except as mentioned, So It won't go into service mode, thks

Share this post


Link to post
Share on other sites
kokomo

At this point I'm stumped as to which control board to replace I'm looking at the center user interface, after referencing this article.                                                                                                  Any suggestion as to removing a board from a bracket with all the clips are special tools needed? do I pull the main control knob?  thks.

1). Put the washer into the Diagnostic Test Mode per the Tech Sheet........in test mode per tech sheet
2). Did the Right Hand Interface light up? ............yes
3). IF the Right Hand Interface did not light up in Step 2 check for 5 VDC on the UIP3 wire connector coming off of the control board to the Right Hand Interface from (Pin 1 to Pin 2) and from (Pin 1 to Pin 3). dna
4). IF you do not have the 5 VDC then remove the MI3 connector from the Machine Control board. IF the display lights; replace the Motor Control board. IF the display does not light; replace the Machine Control Board. dna
5). IF you do have the 5 VDC then replace the Right Hand User Interface. dna
6). IF the Right Hand Interface does light up. Lock the controls by pressing the control lock button for 3 seconds.........hold 3 sec to lock yes.
7). Once the control has been locked press the power pad. IF the control lock light blinks when the power button is pressed it tells us the power button is sending the output from being pressed to the right hand interface but the right hand interface is not responding and will need to be replaced..........after pressing power button cntrl lock light does not blink & I get the shut down tone Diagnostic Test Mode terminates.
8). IF the control lock light does not blink when the power button is pressed replace the center user interface.

Share this post


Link to post
Share on other sites
JacksonApplianceRepairCO

sounds like you may have a motor control board issue. Hard to tell with these, they can be really troublesome.

Share this post


Link to post
Share on other sites
kokomo

Thanks Jackson App.

The unit will go thru a complete wash cycle in service mode, a detailed wiring schematic would be very useful.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.