Learn how to troubleshoot using schematics like a real tech…

Click here to check out our structured, online appliance repair training courses for rookies and experienced techs.

FAQs | Repair Videos | Academy | Newsletter | Podcast | Contact

Stay connected with us...

Samurai on Facebook - become a fan today! Sign up for our free newsletter and keep up with all things Appliantology. Subscribe to our YouTube channel for lots of appliance repair tips and help! Follow the Samurai on Twitter and get timely morsels of Appliantological Wisdom! Subscribe to our MST Radio podcast to learn secrets of the trade.
  • Announcements

    • Samurai Appliance Repair Man

      [Webinar] Basic Refrigeration Sealed System Thermodynamics   09/21/2017

      See this calendar event for details:                   
    • Samurai Appliance Repair Man

      Webinar Recordings Index Page   09/21/2017

      One of the benefits of your Professional Appliantologist membership is that you can attend the regular, live training webinars and you have access to the recordings as well. So if you can't make it to the live webinar, catch the recording at your convenience. The webinar recordings are conveniently listed for you on the Webinar Recordings Index Page.   

Archived

This topic is now archived and is closed to further replies.

IT_tech

Condensing Unit / Fan not working

Recommended Posts

IT_tech   
IT_tech

Hello,  Not doing so well here in CA. it is 105+ outside and my sisters condensing unit quit working. there has been power outages lately. and I think also in the same day.

((The Carrier Condensing Unit is not working. just makes clicking sounds. Nothing comes on. no other sounds.))

When I call for cooling, the blower unit works fine, (obviously blowing warm air) but outside I can hear clicking sounds, and the whole unit will not come on. looking at the contactor, it operates. (pulls in and stays in), and it tests out both sides of the contactor/ at 115VAC when in the out position and in position. . and the connections for thermostat show 24VAC.  it is a double pole 40 breaker fuse. ((also nothing operates when i manually push in the contactor.))

and when i check the plug at the condensing unit, it has power too.

not sure the best way to check the capacitor / and discharge it, I have heard differing ways, one was to short it out with a 10k/1w ohm resistor.

how do i check the capacitor safely? to figure if it is bad or good?

this is frustrating, i can rebuild computers, and configure them to my hearts delight, but testing this unit and figuring out what is wrong is frustrating. I have schematics and a book form the Airconditioning Institute. but it does not explain well enough to help here.

 

Share this post


Link to post
Share on other sites

Need appliance parts? Call 877-803-7957 now!

AccApp   
AccApp

You need to have 240v going to the outside unit to operate. It sounds like you don't. Measure it across the two incoming wires. It is very unlikely that the fan motor and the compressor would fail at the same time.

When you push the relay in, the fan and compressor should come on if there is power to the unit.

Share this post


Link to post
Share on other sites
jehiatt   
jehiatt

Sounds right - one side of your fuse or breaker is open.

Share this post


Link to post
Share on other sites
applianceman18007260692   
applianceman18007260692

go back into the arcives to find pregnant capacitor by me and you will get a good explanation of capicitor woes

 

Share this post


Link to post
Share on other sites