Jump to content
Click here to check out our on-demand appliance repair training webinars.

FAQs | Repair Videos | Academy | Newsletter | Contact


  • Upcoming Events

    • 27 April 2024 02:00 PM Until 03:00 PM
      5  
      All Appliantology tech members are invited to join in this workshop on all things Appliantological. 
      We have a special session planned for this one. Instead of the usual Show 'n Tell on a technical topic, we're going to post tech sheets in the comments to this Calendar Event (scroll down to see what's posted so far) and ask specific questions that can only be answered by reading the tech sheet. If you at least try to answer the questions beforehand, you'll get a lot more out of it. The tech sheet and the questions are posted in the comments section below.
      Your mission, if you should choose to accept it, is to check out the questions for each one and try to answer them ahead of time. Then come to the Dojo to see how well you did! 
      Who: This workshop is only available to tech members at Appliantology.
      When: Saturday, April 27 @10:00 AM Eastern Time.
      Where: Online via Zoom
      How:
      Click here to go to the forum topic with the registration link. If you're interested, register now. Arrive a couple minutes early to make sure your connection is working. Set a reminder for yourself for this workshop so you don’t miss it.  And check out past workshops here: https://appliantology.org/announcement/33-webinar-recordings-index-page/

Recommended Posts

I am asking for a repair manual for a whirlpool dryer mod. # wed9200sq1. It keeps blowing high limit thermostats intermittently. Do you have any nifty ideas why? I mean besides a short some where that we can not find.

Link to comment
Share on other sites

  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

  • RegUS_PatOff

    1

  • abbinoxious

    1

Popular Days

Top Posters In This Topic

could be a Heating Element partially shorted to chassis / ground

could be a Venting problem

 

What are the Vent temperatures ?

With an empty load, Timed Dry, High Heat, the vent temperature should cycle somewhere between 135F and 160F

Check the Vent air temperature at the back of the Dryer using a probe-type thermometer.

If you have a Harbor Freight Store near you,
click on picture $ 2.99 sometimes on sale
image_1255.jpg

Dryer Vent:
Vent should be rigid metal.
Short lengths of flexible metal may be OK, if not crimped when moving the Dryer into place.
NO plastic
NO PVC
NO screws
Foil Duct Tape is OK.

Check / clean the Dryer Vent

Disconnect the Dryer Vent and check for good air-flow there and where it exits the house.

 

Whirlpool Dryer
WED9200SQ1

Repair Part List - W10194580
Tech Sheet - W10198666


was:

Tech Sheet - W10177459A
Tech Sheet - W10177459

 

available after upload approval by the Samurai

 

Link to comment
Share on other sites


×
×
  • Create New...