Jump to content
LIMITED TIME OFFER: Get up to $100 off tuition for Master Samurai Tech courses through November 30th ×
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


Search the Community

Showing results for tags 'hotpoint washer'.

  • Search By Tags

    Type tags separated by commas.

  • Search By Author

Content Type


Forums

  • Appliantology Welcome Center
    • Site Orientation
    • Announcements
  • Professional Appliance Technician Forums
    • Appliance Repair Tech Forum
    • Master Samurai Tech Workshops
    • Samurai's Appliance Repair Video Classroom
    • Samurai’s Appliance Puzzles
    • The Dojo
  • Appliance Service Manual Requests
    • Appliance Service Manual Requests Forum
  • Appliance Repair Trade Resources
    • Looking for a Tech
    • Looking for a Job
    • Appliance Repair B2B Resources
  • DIYer Appliance Repair Forums
    • DIY Appliance Repair Help
    • Appliance Haikus

Blogs

  • Samurai Appliance Repair Man's Blog
  • kdog's Blog
  • Mrs. Samurai's Kitchen
  • DurhamAppliance's Blog
  • applianceman97's Blog
  • LI-NY Tech's Blog
  • tpoindexter's Blog
  • Eugene's blog about stores, fixing, life, and more!
  • Appliance Repair Tech Tips
  • Koi Guy's Amazing Compendium of Timeless Appliantological Wisdom
  • Rhubarb Tau's Sloggy Vlog Blog Bog

Categories

  • Appliance Repair Manual Stash Access File®
  • Appliance Repair Manual Pot Luck Supper

Find results in...

Find results that contain...


Date Created

  • Start

    End

Last Updated

  • Start

    End

Filter by number of...

Found 1 result

  1. harrybison
    Hotpoint Washer fills, drains but no spin or agitation. Lid switch passed continuity test. It started with occasional not pinning then no spinning and now no agitation, either. I opened up the front and checked for some visible trouble, but it looks as good as new (6 years old) and nothing loose. The motor occasionally turned with slow agitation and even spinned a bit once as I was testing it, but no more. Motor assembly looks very clean, LED on the circuit board lights 1 sec ON / 1 second OFF, indicating stand by mode while the timer goes thru its stages and clicking between modes as though it is working fine. Any ideas what it could be? Is there an easy way to test the timer with a multimeter? I am thinking of replacing the timer?
×
×
  • Create New...