Jump to content
LIMITED TIME OFFER: Get up to $100 off tuition for Master Samurai Tech courses through November 30th ×
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


Search the Community

Showing results for tags 'spray arm loose'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Appliantology Welcome Center
    • Site Orientation
    • Announcements
  • Professional Appliance Technician Forums
    • Appliance Repair Tech Forum
    • Master Samurai Tech Workshops
    • Samurai's Appliance Repair Video Classroom
    • Samurai’s Appliance Puzzles
    • The Dojo
  • Appliance Service Manual Requests
    • Appliance Service Manual Requests Forum
  • Appliance Repair Trade Resources
    • Looking for a Tech
    • Looking for a Job
    • Appliance Repair B2B Resources
  • DIYer Appliance Repair Forums
    • DIY Appliance Repair Help
    • Appliance Haikus

Blogs

  • Samurai Appliance Repair Man's Blog
  • kdog's Blog
  • Mrs. Samurai's Kitchen
  • DurhamAppliance's Blog
  • applianceman97's Blog
  • LI-NY Tech's Blog
  • tpoindexter's Blog
  • Eugene's blog about stores, fixing, life, and more!
  • Appliance Repair Tech Tips
  • Koi Guy's Amazing Compendium of Timeless Appliantological Wisdom
  • Rhubarb Tau's Sloggy Vlog Blog Bog

Categories

  • Appliance Repair Manual Stash Access File®
  • Appliance Repair Manual Pot Luck Supper

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Found 1 result

  1. Greetings, my KUDS24SEAL5 was not cleaning very well. I noticed the lower spray arm was VERY wobbly. It spins freely, but is VERY wobbly. Yesterday, I replaced the washer arm bearing (WP9742946) which was worn paper thin. I also replaced the split ring bearing (WP3376846) on the bottom of the spray arm as well. Though not part of this discussion, I replaced the split ring bearing on the upper washer arm as well. I have only run one small load since, and it appears to clean better. Too early to tell at this point. One thing that bothers me is that even after replacement of the lower washer arm bearings, the spray arm was VERY still wobbly. I didn't expect it to be. The spray arm has what I would estimate to be 1/8" - 3/16" axial play if I pull directly up on the spray arm. How wobbly should this spray arm be? Is there a clearance spec for it? Could the flange on the spray arm nut be worn so much to allow this wobble, or is the wobble normal? It doesn't look worn at all. Thanks.
×
×
  • Create New...