Search the Community

Hi Everyone I recently purchased this GE Washer . Used it for about 20 loads. Did 2 loads this morning(no issues) and on the 3rd load the tub stopped filling with water. My process is that I lift the lid and the machine wakes up and I close the lid . I then press the start button and it would normally give a squirt and pause then another squirt and pause and then on the third time I would hear a click noise and it will fill. no issues. assuming the sensors are doing their job This morning as I was doing the load on the 3rd squirt no water would come out. Just a hum and the lid locked . I thought I heard a loud noise this morning on the 3rd squirt and that when the lid locked .I was able to unlock the lid and start over but now what I am experiencing is that on the 3rd squirt water would come out for about 5 seconds and then shut off . if I open the lid and close it and press the start then it will start filling and shut off in about 5 seconds. I check the hoses and water was blasting out . I didn't notice any debris on the inlet screens. I am able to turn dial and to drain & spin and it drains the water out and spins I haven't opened up the control panel but from what I can see i would need to two 1/4 hex head screws on each side and then pop it off the metal bracket. Any advice would be greatly appreciated Wayne