Whirlpool WFW9500TW01 F35

[eyesonly1]

I have a whirlpool WFW9500TW01 with the F35 error. I've watched your video on youtube about it.  I’ve replaced both the Control board and APS, Trap is clean at the bottom but It still won’t get to C-01. 

 

I hold down the steamer check buttons to test and it says YES. Unplugged the APS, still getting the F35 error. Plugged it back in, still F35. The little motor next to the drain is running so it seems to be pumping.

 

I’m at a loss here. I hope you can help.

[Thirstytech]

Have you pulled the filter out of the drain pump and cleaned it?

 

[eyesonly1]

you mean the thing at the bottom middle. Yeah unscrewed that, water came out and nothing in there. Blew into the black hose for the APS. Still F35

[sh2sh2]

What control board did u replace

[AARDL]

Up at the very top is place for search type in F-35 and enjoy the read there's lots of information on this site about F-35p the samurai even has a video pertaining to the F-35 if I'm not mistaken

Edited April 16, 2016 by AARDL

[eyesonly1]

2 hours ago, sh2sh2 said:

What control board did u replace

The main CCU board in the front. Didn't touch the steam unit board

[eyesonly1]

1 hour ago, AARDL said:

Up at the very top is place for search type in F-35 and enjoy the read there's lots of information on this site about F-35p the samurai even has a video pertaining to the F-35 if I'm not mistaken

yeah I saw that video. I did everything he said in the video and still get the F35

[sh2sh2]

Was the new pressure sensor in a sealed bag?

[eyesonly1]

yep bought it off here, well the link from here to the place to buy it.