Whirlpool dryer WED9400SW0 - installing electronics control board

[BB430]

Installing new board (part W10110641), but embarrassingly, I didn't take a photo of the wire setup before it was removed.  I got all the wires back in, and I don't think there was really any other way to do it.  But I'd like to confirm that if possible before firing it up.  Anyone happen to know where I can find a photo of the wires online or something?

[sh2sh2]

Take a picture and I can tell if it's right, but they should only go in one way

[BB430]

I'm sorry, I can't get the photos to insert. I'll keep trying...

[BB430]

[sh2sh2]

Looks good!

[Samurai Appliance Repair Man]

8 minutes ago, sh2sh2 said:

Looks good!

[BB430]

So, I can just put all the covers back on and fire it up?  I'm so scared of doing something dumb and blowing out a $180 board...  Any need to recheck the thermal fuse, thermistor, thermal cutoff etc that I also replaced?

[sh2sh2]

From what I can see and what u describe you are ready to go

[BB430]

It's working!!!  On Air Only, the heating element didn't light up, and then on Medium heat, it lit up and then I heard a click and it went off, then a few moments later, it came back on. I assume that's the thermal cutoff doing it's job correctly.  Thank you so much for your input!

[pmjallow]

I install a new board on this model with error F01 now I am getting F70 Communication error, any suggestions 

[pmjallow]

Note: all wires are connected properly "triple check "