Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


DISCLOSURE: We may earn a commission when you use one of our coupons/links to make a purchase.
  • Upcoming Events

    No upcoming events found

FPMC3085KFB wall combo, microwave access?


jay jay

Recommended Posts

I need to check out a microwave oven.  Unusual noise, now no heat.  
My question is, do I have to pull the whole oven / microwave out of the wall?
Perhaps there is access if the control panel is removed, but I don't think so.
I plan on looking at the unit for the first time tomorrow, but am hoping for a heads-up.

Yes, I am aware of the HV hazard.  I am a ham radio operator and familiar with the HV safety procedures.

Saludos

Link to comment
Share on other sites

  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

  • jay jay

    2

  • darren412

    1

Top Posters In This Topic

its possible if you just remove the trim kit around the microwave , that the microwave may just slide out after that.   I dont think the microwave is attached at any point to the oven. Its possible but I dont think it is.  Sounds like you just need a new mag and diode.   good luck

Link to comment
Share on other sites

Thanks Darren,

There is a mounting frame installed on top of the oven and the microwave is mounted to it.  Very difficult to reach the screws.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...