Is this normal? MDE9700AYW Maytag Electric Dryer

[Chris Knable]

I opened up this dryer today for cleanout and there was black tar material (probably drum dampening material) all over the bottom and sides of the dryer. It covers the heating coil shroud (actually baked on pretty good), the exhaust vent tube, and wiring.

Is this normal?

Can it ignite?

Does it need to be removed?

Wanted to post a picture but I couldn't figure out how to do that...

[Vance R]

On 2/19/2021 at 7:08 AM, Chris Knable said:

Is this normal?

No

 

On 2/19/2021 at 7:08 AM, Chris Knable said:

Can it ignite?

Possible

 

On 2/19/2021 at 7:08 AM, Chris Knable said:

Does it need to be removed?

Yes, also check your vent for restrictions or blockage. Sounds like the inside of the dryer cabinet got too hot

[SbyApps]

Agreed. I think Knable is right. Maybe shorted element, bad thermostat or bad control board.. something caused it to overheat and melt the dampening crap

Edited February 22, 2021 by SbyApps

[evaappliance]

Not to uncommon for the soundproofing to turn loose after several years without any problems in the dryer