Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


Search the Community

Showing results for tags '15652'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Appliantology Welcome Center
    • Site Orientation
    • Announcements
  • Professional Appliance Technician Forums
    • Appliance Repair Tech Forum
    • Master Samurai Tech Workshops
    • Samurai's Appliance Repair Video Classroom
    • Samurai’s Appliance Puzzles
    • The Dojo
  • Appliance Service Manual Requests
    • Appliance Service Manual Requests Forum
  • Appliance Repair Trade Resources
    • Looking for a Tech
    • Looking for a Job
    • Appliance Repair B2B Resources
  • DIYer Appliance Repair Forums
    • DIY Appliance Repair Help
    • Appliance Haikus

Blogs

  • Samurai Appliance Repair Man's Blog
  • kdog's Blog
  • Mrs. Samurai's Kitchen
  • DurhamAppliance's Blog
  • applianceman97's Blog
  • LI-NY Tech's Blog
  • tpoindexter's Blog
  • Eugene's blog about stores, fixing, life, and more!
  • Appliance Repair Tech Tips
  • Koi Guy's Amazing Compendium of Timeless Appliantological Wisdom
  • Rhubarb Tau's Sloggy Vlog Blog Bog

Categories

  • Appliance Repair Manual Stash Access File®
  • Appliance Repair Manual Pot Luck Supper

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Found 1 result

  1. One day the "Lock On" LED on our Kenmore Dishwasher is lit, and the dishwasher won't start. I find: I follow the suggestions, remembering that I'd done something like this, successfully, once before. Then I remember the key step. You have to disconnect the controller-to-front panel ribbon cable, THEN close-up the cover and inner door, FINALLY Close The Door! You won't see anything happening, no LED, and the buttons don't work. All disconnected. BUT, if you then open it all up and reconnect the ribbon cable, then close it up again, in 2 out of 2 cases, the "Lock On" LED will be out and the dishwasher will start and run! Its not just disconnecting the power cables from the controller board, opening the circuit breaker to the dishwasher, or disconnecting the ribbon cable from controller to panel. You must disconnect the ribbon cable, then close the door so the controller powers up without the panel connected, power down, reconnect and power up again. Just like you were troubleshooting whether it was the controller or the front panel. Its BOTH, but if you disconnect them, it will clear.
×
×
  • Create New...