Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


Search the Community

Showing results for tags 'maytag mff2558vem4'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Appliantology Welcome Center
    • Site Orientation
    • Announcements
  • Professional Appliance Technician Forums
    • Appliance Repair Tech Forum
    • Master Samurai Tech Workshops
    • Samurai's Appliance Repair Video Classroom
    • Samurai’s Appliance Puzzles
    • The Dojo
  • Appliance Service Manual Requests
    • Appliance Service Manual Requests Forum
  • Appliance Repair Trade Resources
    • Looking for a Tech
    • Looking for a Job
    • Appliance Repair B2B Resources
  • DIYer Appliance Repair Forums
    • DIY Appliance Repair Help
    • Appliance Haikus

Blogs

  • Samurai Appliance Repair Man's Blog
  • kdog's Blog
  • Mrs. Samurai's Kitchen
  • DurhamAppliance's Blog
  • applianceman97's Blog
  • LI-NY Tech's Blog
  • tpoindexter's Blog
  • Eugene's blog about stores, fixing, life, and more!
  • Appliance Repair Tech Tips
  • Koi Guy's Amazing Compendium of Timeless Appliantological Wisdom

Categories

  • Appliance Repair Manual Stash Access File®
  • Appliance Repair Manual Pot Luck Supper

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Found 1 result

  1. I have an 8 year old Maytag french door refrigerator which has been troublesome for the past 5 years ago. It started with the ADC failure. I replaced the evaporator fan motor and jazz board and bought a surge protector. Last year the duck bill drain plugged leaving water on the floor and giving the box a "bladder control issue" according to my daughter. Whirlpool sent a free p trap replacement. This weekend it again developed the cold freezer and warm fridge symptom. There was modest frost build-up in the freezer, but not as bad as 5 years ago when I replaced the control board. I followed the Samurai’s advice and put it into forced defrost mode and could hear the condenser fan continue to run, so I thought the ADC/Jazz board needed replacement again. I continued the rest of the troubleshooting steps to make sure that there were no other bad parts and low and behold the evaporator fan began blowing cold air into the fresh food compartment. The fresh food compartment has cooled, but I'm not sure if the coils will completely defrost after a few days or if I need to turn the box off and let the ice all melt off. I'm also not sure if the fix is permanent or if it will frost up again and I will eventually need to replace the ADC/Jazz board again! Any advice appreciated!
×
×
  • Create New...