Search the Community

Hi all... DIYer here and would love some guidance. I have a Whirlpool Cabrio Washer (WTW6400SW3) with an OL Error Code during normal cycle. I'm struggling to figure out what is wrong with it. Below are steps ALREADY performed (with Empty Washer - no load) and other symptoms: Gets OL Error code (70) on Manual Diagnostics Finishes Automatic Diagnostics without errors Runs "Rinse & Spin" cycle without errors. Machine seems to exhibit stronger shimmy/shake when the drain pump is running; without drain pump running, runs pretty smoothly. Drain pump does have a decent loud hum/buzz. Checked stator - has no cracks Found indications to check stator (done) and otherwise replace balancing shocks (not done yet). Doesn't seem like there's much to the shocks (just springs?) but I guess these could go bad? I've put a lot of effort into this puppy with multiple repairs over the years... and so far have kept it running!! Would love to continue to do so, as I now understand pretty well how it works. (Prior repairs: New electronics board, replaced the stator and rps, replaced the hub, replaced the drive and bearings.