Jump to content
LIMITED TIME OFFER: Get up to $100 off tuition for Master Samurai Tech courses through November 30th ×
Click here to check out our on-demand appliance repair training webinars.

FAQs | Repair Videos | Academy | Newsletter | Contact


About This File

GE Refrigerator Ice Maker Fill Tube Freeze Repair Kit

Built-In Side-by-Side Energy Model:

ZIS360N, ZISB360D, ZISW360D, ZISS360N, ZISS360D

ZIS420N, ZISB420D, ZISW420D, ZISS420N, ZISS420D

ZIS480N, ZISB480D, ZISW480D, ZISS480N, ZISS480D

Built-In Bottom-Freezer Models:

ZIC360N RH, ZIC360N LH, ZICS360NRH, ZICS360NLH

All-Freezer Models:

ZIFS36NLH, ZIFS36NRH, ZIF36NMRH, ZIF36NMLH

REPAIR KITS:

WR49X10093 for BOTTOM-FREEZER MODELS:

Contains 1 fill tube/foil heater assembly, 1 grommet,

1 connector adapter, 1 heater sleeve, 1 fill tube

cover, 4 wire tie.

WR49X10094 for SXS NON-DISPENSER AND ALL-

FREEZER MODELS: Contains 1 All freezer fill tube,

1 SxS non-dispenser fill tube, 1 wrap type fill tube

heater, 1 grommet, 1 connector adapter.

WR49X10100 for SXS DISPENSER MODELS:

Contains 1 fill tube/foil heater assembly, 1 grommet,

1 connector adapter, 1 heater sleeve, 4 wire tie.

This bulletin provides information on kits available to

repair icemaker fill tube freezing and water leaking

between the grommet and fill tube on Monogram

Energy Model refrigerators.

CONSUMER COMPLAINTS: “no ice production”,

“water/ice in freezer bottom”, “icemaker is leaking

water in back corner”…

Icemaker fill tube freezing and water leaking at the

grommet could have several causes.

1.Check the following before ordering kit:

•Tubing kinks

•Clogged filter or water valve

•Loose tubing connections

•If consumer has low water pressure or other

filtration systems, remove the SmartWater™

filter and install bypass cap permanently.

2. In some units the wrap-type wire heater does not

provide enough heat to melt accumulating ice.

Replace wire heater with a foil type heater in all

BOTTOM-FREEZER and SXS DISPENSER

MODELS.

3. If water leaks between the grommet and fill tube,

and the grommet does not seal tightly around the

tube, the grommet must be replaced.

NOTE:ACCESS TO BACK OF REFRIGERATOR IS

REQUIRED FOR THIS REPAIR. GE recommends

two technicians move the refrigerator in order to

replace the fill tube grommet.


User Feedback

Recommended Comments

There are no comments to display.

×
×
  • Create New...