Jump to content
LIMITED TIME OFFER: Get up to $100 off tuition for Master Samurai Tech courses through November 30th ×
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


Search the Community

Showing results for tags 'beeps only'.

  • Search By Tags

    Type tags separated by commas.

  • Search By Author

Content Type


Forums

  • Appliantology Welcome Center
    • Site Orientation
    • Announcements
  • Professional Appliance Technician Forums
    • Appliance Repair Tech Forum
    • Master Samurai Tech Workshops
    • Samurai's Appliance Repair Video Classroom
    • Samurai’s Appliance Puzzles
    • The Dojo
  • Appliance Service Manual Requests
    • Appliance Service Manual Requests Forum
  • Appliance Repair Trade Resources
    • Looking for a Tech
    • Looking for a Job
    • Appliance Repair B2B Resources
  • DIYer Appliance Repair Forums
    • DIY Appliance Repair Help
    • Appliance Haikus

Blogs

  • Samurai Appliance Repair Man's Blog
  • kdog's Blog
  • Mrs. Samurai's Kitchen
  • DurhamAppliance's Blog
  • applianceman97's Blog
  • LI-NY Tech's Blog
  • tpoindexter's Blog
  • Eugene's blog about stores, fixing, life, and more!
  • Appliance Repair Tech Tips
  • Koi Guy's Amazing Compendium of Timeless Appliantological Wisdom
  • Rhubarb Tau's Sloggy Vlog Blog Bog

Categories

  • Appliance Repair Manual Stash Access File®
  • Appliance Repair Manual Pot Luck Supper

Find results in...

Find results that contain...


Date Created

  • Start

    End

Last Updated

  • Start

    End

Filter by number of...

Found 1 result

  1. DotYrslefguy
    Hello, any help would make me a hero. Original problem - two year old dishwasher just stopped working. No lights, no nothing. Solution - I ordered a new control board like this one https://partsdr.com/part/wd21x24798-control-board I installed it an the lights came on! New Problem When I press start, it just beeps two times. What I have tried: Cut power and wait 10 minutes - no change CONSUMER ERROR MODE :Press and hold the Cycle Select and Start pads simultaneously for 5 seconds.- this showed me door was properly closed. weird thing is that after all the lights went out that indicated door was properly shut, I was able to press start and it ran through a whole cycle. BUt still will not start. I think either have a defective part, or this board somehow needs to be synced to the machine somehow, and I though cutting the power would accomplish that. Any Suggestions? Thanks!
×
×
  • Create New...