Search the Community

I have a Maytag Atlantis MAV7600AWW. The other day it was running and it started making loud noises (cant remember what it sounded like) then it stopped all together and smelled like burning rubber. I assumed it was the belt so i replaced that. Turned it on again and the motor just hummed and started smoking. I did some research and from mostly what i read made me believe it was the motor. I got a motor and replaced it, and it still is having the same issue. The water fills fine, then when it gets to spin, the timer buzzes and the motor hums and smokes. It seems like something is restricting the motor. I was able to turn the drum from the pulley side and the inside of the drum, the drain pump is a little hard to turn by hand but it does turn. I am lost now on what could be wrong. The two things i can think of would be a capacitor(not sure if it has one) or the pump is seized. Again the drum and motor spin by hand with ease. Anyone know what else i could do, i dont want to spend anymore money on it unnecessarily. Cheers Adam

My GE spacesaver (JVM1430BD) stopped working in the middle of microwaving and blew the inline fuse. After some digging and testing, it turns out the capacitor was bad (continuity between the two sides). I ordered a new one with nearly the same specs (2100wvac and 0.86uF on old vs 2100wvac and 0.91uF on new). When the part came it was about 0.5" shorter than the old one but otherwise fit into the holder etc. I installed it and turned the microwave back on...everything worked again. I microwaved some water and it heated it just as expected in the same amount of time as before the capacitor went out. An hour later I was in the kitchen and noticed a very soft hum. It was coming from the microwave and was very soft. The only reason I heard it was because the fridge had stopped its cycle and everything was dead silent in the kitchen. I took the cover off thinking it was the new capacitor or the diode. The sound actually seems to be coming from the HV transformer. While the microwave still had power to it, I went ahead and unplugged the diode from the capacitor for a few seconds wondering if maybe the old diode was bad and drawing current. Humming stayed the same with the diode attached or not. I re-tested the microwave function and everything still works as expected. Before I installed the new capacitor I had checked resistance for the HV transformer and it was appropriate. I also checked the magnetron for continuity etc. and everything seemed in order. I was convinced that the only thing that went bad was the capacitor. Any thoughts on why the HV transformer is humming. Again, it is very soft but I am convinced that it is louder than it was before the switch. Could the diode be bad despite the contiued hum when I disconnected it? Is the new capacitor not functioning properly? Is the shortened length or minor discrepancy in uF to blame? Most importantly, is a humming transformer dangerous/a risk? It just sounds like a piece of electrical machinery working but it is louder than before the fix. Thanks!