Search the Community

Hello, Our RF135BDRUX4 Fisher Paykel Fridge started having an issue with the water dispenser after several years. It would give only a half-glass or so, then nothing at all, then another half glass, then it will give a whole pitcher, then less a half-glass, etc... I could not find anything in this forum or others about this. Any idea what causes the issue and how to fix it? Thank you all for your wisdom!

I have a Maytag clothes washer, MVWC400XW3, that occasionally doesn't go into the spin cycle. Most of the time, it works fine and the cycle completes with the clothes well-spun. But we've had 3 occasions now in which the spin cycle didn't seem to run at all, and the contents of the washer are very wet with water dripping when we pull the items out. It seems to happen when there's a heavier load in the washer. Twice we had a load of towels, and once it was a bedspread. But we've also had occasions when a similar load ran through without any problems. I've removed the drive splutch assembly to inspect it, and it doesn't show any signs of wear. The motor doesn't make any unusual sounds when it's in the spin cycle. The door latches when the machine is running. When we discover that a load hasn't been spun, I've been able to turn the dial to the "drain & spin" position, press the Start button, and then the load does spin without any apparent problems. What could be the problem? Does it sound like a shift actuator with an intermittent failure?

I'm having a problem with my LG WM2016CW front load washer. I am receiving the LE error code. I have replaced the sensor (apparently the most likely cause of the LE code) and motor harness and still am having issues. The washer goes through part of a cycle and drum will spin before the error hits. After I replaced the motor harness, I ran an empty load and it made it all the way through. Tried with a small load and it made it through to the rinse cycle before the LE error appeared. Any suggestions would be appreciated