Jump to content
Click here to check out this guide

FAQs | Repair Videos | Academy | Newsletter | Contact


Search the Community

Showing results for tags 'med9800tq0'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Appliantology Welcome Center
    • Site Orientation
    • Announcements
  • Professional Appliance Technician Forums
    • Appliance Repair Tech Forum
    • Master Samurai Tech Workshops
    • Samurai's Appliance Repair Video Classroom
    • Samurai’s Appliance Puzzles
    • The Dojo
  • Appliance Service Manual Requests
    • Appliance Service Manual Requests Forum
  • Appliance Repair Trade Resources
    • Looking for a Tech
    • Looking for a Job
    • Appliance Repair B2B Resources
  • DIYer Appliance Repair Forums
    • DIY Appliance Repair Help
    • Appliance Haikus

Blogs

  • Samurai Appliance Repair Man's Blog
  • kdog's Blog
  • Mrs. Samurai's Kitchen
  • DurhamAppliance's Blog
  • applianceman97's Blog
  • LI-NY Tech's Blog
  • tpoindexter's Blog
  • Eugene's blog about stores, fixing, life, and more!
  • Appliance Repair Tech Tips
  • Koi Guy's Amazing Compendium of Timeless Appliantological Wisdom
  • Rhubarb Tau's Sloggy Vlog Blog Bog

Categories

  • Appliance Repair Manual Stash Access File®
  • Appliance Repair Manual Pot Luck Supper

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Found 1 result

  1. Hi guys, I need some help. The symptom is it won't start- I've looked through all the posts I could find. I think it's the motor, or the control board. I've taken apart the whole dryer. No codes. Tested the door switch, the belt switch. the thermal fuse is good. the motor windings seem low. The main was 2.1 ohms, start was 2.0 ohms. spins freely. The control board doesn't have any burns or anything that looks abnormal. I also tested the P1-3 and P1-4 leads and the resistance was in spec, so it says to replace the board. I really don't want to spend 300 bucks on a board if that's not the problem, or if I can just solder a new relay on the board. I can hear the relay click when I hold start in the diag mode. my question is: how do I check the control board, the motor relay, and the motor? Thanks in advance, Marc
×
×
  • Create New...