Jump to content
Click here to check out our structured, online appliance repair training courses for rookies and experienced techs.

FAQs | Repair Videos | Academy | Newsletter | Contact


Search the Community

Showing results for tags 'wed6200sw1'.

  • Search By Tags

    Type tags separated by commas.

  • Search By Author

Content Type


Forums

  • Appliantology Welcome Center
    • Site Orientation
    • Announcements
  • Professional Appliance Technician Forums
    • Appliance Repair Tech Forum
    • Master Samurai Tech Workshops
    • Samurai's Appliance Repair Video Classroom
    • Samurai’s Appliance Puzzles
    • The Dojo
  • Appliance Service Manual Requests
    • Appliance Service Manual Requests Forum
  • Appliance Repair Trade Resources
    • Looking for a Tech
    • Looking for a Job
    • Appliance Repair B2B Resources
  • DIYer Appliance Repair Forums
    • DIY Appliance Repair Help
    • Appliance Haikus

Blogs

  • Samurai Appliance Repair Man's Blog
  • kdog's Blog
  • Mrs. Samurai's Kitchen
  • DurhamAppliance's Blog
  • applianceman97's Blog
  • LI-NY Tech's Blog
  • tpoindexter's Blog
  • Eugene's blog about stores, fixing, life, and more!
  • Appliance Repair Tech Tips
  • Koi Guy's Amazing Compendium of Timeless Appliantological Wisdom
  • Rhubarb Tau's Sloggy Vlog Blog Bog

Categories

  • Appliance Repair Manual Stash Access File®
  • Appliance Repair Manual Pot Luck Supper

Find results in...

Find results that contain...


Date Created

  • Start

    End

Last Updated

  • Start

    End

Filter by number of...

Found 1 result

  1. picktown
    WED6200SW1 model cabrio dryer. Stopped running, was displaying F01 error code in diagnostic mode. Checked all the connections to the main board, everything looked okay so I replaced it. Still would not work, can't remember the new code but research suggested I replace the control interface. That didn't help either. Now the dryer will power on but wil not run. In normal mode, when you press the start button the "sensing" light comes on. In dianostic mode -- door tests ok (beeps when opened and closed), moisture sensor tests ok (beep when connected by one finger). After the "88" appears, when I press the same button used to put it into diagnostic mode, I get "Pr" followed by "23". When I press the START button in diagnostic mode, I get code "C5". I can't find any documentation on these wacky codes anywhere. I was planning to step through the troubleshooting (on the tech sheet) to see if I can track it down. Any suggestions or shortcuts?
×
×
  • Create New...